Перейти к основному содержанию

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Английский
Китайский
Step 2
Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case.
  • Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger

  • Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case.

  • If the adhesive is very difficult to separate, reheat the rear panel and try again.

从最靠近基座连接器的电池单元开始,在最靠近逻辑板的电池边缘下用塑料撬棒撬开,以留出足够的空间来插入平口撬棒。

在每个电池单元的两个长壁上插入一个平口撬棒,将它们与固定在后面的胶粘剂完全分开。

如果胶粘剂很难分离,重新加热后面板再试一次。

Ваш вклад лицензируется под свободной лицензией Creative Commons.