Перейти к основному содержанию

Notice: You are editing a prerequisite guide. Any changes you make will affect all 23 guides that include this step.

Английский
Японский
Step 11
In the next four steps, take care to pry up only on the cable connectors, and not on their sockets on the logic board. Use a spudger or a fingernail to disconnect the front-facing camera and sensor cable connector.
  • In the next four steps, take care to pry up only on the cable connectors, and not on their sockets on the logic board.

  • Use a spudger or a fingernail to disconnect the front-facing camera and sensor cable connector.

次の4つの手順ではケーブルコネクターのみに差し込んで持ち上げ、基板上のソケットには接触しないでください。

スパッジャーの平面側先端を使って、正面カメラとセンサーケーブルコネクターの接続を外します。

[* icon_caution] In the next four steps, take care to pry up '''only''' on the cable connectors, and not on their sockets on the logic board.
[* black] Use the flat end of a spudger or a fingernail to disconnect the front-facing camera and sensor cable connector.
[* black] Use the flat end of a spudger or a fingernail to disconnect the front-facing camera and sensor cable connector.

Ваш вклад лицензируется под свободной лицензией Creative Commons.