Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Английский
Китайский
Step 5
Use the flat end of a spudger to pry the hard drive thermal sensor bracket up off the adhesive securing it to the hard drive.
  • Use the flat end of a spudger to pry the hard drive thermal sensor bracket up off the adhesive securing it to the hard drive.

  • If the adhesive gets dirty or will not stick to your new hard drive, place some double-sided tape under the two semicircular ears of the thermal sensor bracket.

使用撬棒的扁平端将硬盘驱动器温度传感器支架从将其固定在硬盘的粘合剂上取下。

如果粘合剂变脏或不会粘到新的硬盘驱动器上,请将一些双面胶带贴在热传感器支架的两个半圆形耳部下方。

Ваш вклад лицензируется под свободной лицензией Creative Commons.