Galaxy J3 (2016) Screen

Моя проблема

The customer had broken the LCD Panel underneath the digitizer. The screen was no longer displaying anything, but the phone was still receiving call and text notifications.

Моё решение

The repair was extremely easy. Some screws, a little heat, some prying, and the old screen was out. Tested the new screen assembly, then removed the adhesive protector strips and installed.

The entire process took maybe 5 minutes and the actual replacement part took about 2 minutes.

Мой совет

Make sure you use plenty of heat if the panel is broken anyway. That makes removal a breeze.

Use a little heat after reinstalling and set some books or a phone-safe vise on the device to help hold it in place while the adhesive cools back down.

Моя проблема

Customer had a cracked screen.

Моё решение

The repair went well once I used a part from Ifixit. At the time the customer originally requested a replacement Ifixit was out of stock so I made the mistake of buying a screen elsewhere. The other parties adhesive wouldn’t stick to the phone properly. The Ifixit screen worked perfectly!

Мой совет

When replacing the screen leave the plastic on that covers the glass. Take a very small peice of adhesive stripping and place it on the top of the home button. Place the home button in its resting place on the screen. The adhesive will stick to the plastic screen covering and hold the button in place while you place the screen on the device.

Моя проблема

Crack digitizer and LCD

Моё решение

Well, after installing the first LCD assembly I got a vertical line down the screen. Pushed it out to reset but upon doing that, the glue holding the screen and LCD failed resulting in the destruction of the LCD. Ordered a new one and had no issue.

Мой совет

Check your part thoroughly to be sure it is assembled correctly

Моя проблема

My Samsung J3 digitizer was broken (the screen was not).

Моё решение

The way the digitizer was damaged, it made removal very hard as it stuck to the housing and cracked and crumbled further into shards on the bottom half (tge area opposite where the battery is housed) when I tried to remove it. In some cases I could remove the copper colored adhesive and remove parts of the digitizer. In the central areas tge digitizer left behind a black substance on top of the adhesive. Because of the nature of the damage and removal of the old digitizer it made the replacement take over an hour. After everything was removed, including the adhesive residue in some areas, the installation of the new digitizer was a breeze. Thanks!

Мой совет

use gloves