Инструменты для этого Разбора

Введение

This is a basic teardown of the venerable TI-82 calculator.

This teardown is not a repair guide. To repair your Texas Instruments TI-82, use our service manual.

The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back.  This is a nice touch, as it makes the cover much more difficult to lose.
  • The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back. This is a nice touch, as it makes the cover much more difficult to lose.

Добавить комментарий

Flip the device over to access the battery cover. Using a spudger, pry the release tab down and then pull the battery door up and off the calculator. Remove:
  • Flip the device over to access the battery cover.

  • Using a spudger, pry the release tab down and then pull the battery door up and off the calculator.

  • Remove:

    • 2 7.2mm Phillips #0 screws

    • 1 15.3mm Phillips #0 screw, and a battery retaining clip.

  • The CR1616 coin cell battery preserves settings and programs in memory while the main batteries are being changed.

Добавить комментарий

Insert a spudger into the seam between the two halves of the case, and pry it apart.
  • Insert a spudger into the seam between the two halves of the case, and pry it apart.

  • Watch out for corrosion in older calculators around the battery terminals -- this is why you should never leave batteries in electronics for extended periods of time.

Добавить комментарий

Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.
  • Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.

  • Remove four Phillips screws to access the electronics underneath, then pull the shield away.

Добавить комментарий

... And, here's the guts of the thing.
  • ... And, here's the guts of the thing.

    • SRM20255LLM10 / F4ZM1938 (32Kbyte SRAM)

    • LH531GP4 (Mask ROM)

    • T 84C00AM-8 (Z80 CPU)

    • Toshiba / TC14L010AF / 1273 9506EAI (ASIC)

Добавить комментарий

Remove the remaining Phillips screws. The screen and main board will lift out, leaving the membrane keypad in the front case.
  • Remove the remaining Phillips screws.

  • The screen and main board will lift out, leaving the membrane keypad in the front case.

Добавить комментарий

bushing

Участник с: 23.04.2010

9 130 Репутация

Автор 17 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 1

За 7 дней: 12

За 30 дней: 48

За всё время: 14,688