Этот профиль еще не завершен.
Вопросы
Pins look fine in the port, device reset did not work at all
Читать далееI have a 3ds that wont play games and found a missing pin inside, i had a faulty 3ds so i used the slot from that and it...
Читать далееI replaced the d pad pcb which i ordered online. The d pad still does not work, everything else seems to be fine BUT the d...
Читать далееI have a DSi with a non working touch screen and a non working d pad all the other buttons work. I have located the d pad...
Читать далееI have a dsi xl that wouldnt charge, i installed a new power connector and it worked but a wk later it would charge only...
Читать далееОтветы
http://cgi.ebay.com/ws/eBayISAPI.dll?Vie...
Читать далееchances are you corrupted the bios or you killed the board you may have a gpu issue as well its hard to say since the mistake you made is quite dangerous
Читать далееits probably overheating IF you are getting a picture if there is no picture than you have the YLOD
Читать далееThe heat gun will simply not do You need to get the solder balls underneath the chip to 225c and will require bottom and top heat without proper equipment there is no possible way to get it to that temperature and sustain it without damaging other components or the board itself
Читать далееits not caused by overheating its caused by solder joints the system needs to be reflowed or reballed or have the rsx chip be replaced It is believed that the main cause of the Yellow Light of Death is due to the chip getting so hot during heavy use of the console that the tiny solder points on the GPU liquefies, and over time loses its connection with the motherboard. This is however untrue as in order for the solder to melt the chip would have to reach a temperature of at least 217c which is impossible. The real cause however does have to do with heat, which causes micro fractures in the solder but does not in no way melt it. source: http://xmoddz.com/ps3-repair
Читать далееProbably fuse related if its charging and not turning on
Читать далееThe problem is the speaker or camera cables. It's usually the speaker cables—rarely is it the camera. The cable will have a micro tear on it due to the opening and closing of the 3DS. The manufacturer should have protected the ribbon cables.
Читать далееI just bought a $500 JBC so i have the right tools now I can do the pad replacement, i dont know how to lift pads from the other boards to place them on the damaged board They repair kits i found are a grand at least
Читать далееyea i need the same part myself, ebay doesnt seem to have it but i will keep looking
Читать далееI have a similar issue, replaced the laser and it makes a noise and gives disk error Put the old laser in and it did not make noise but gave disk error
Читать далее