Joy McLaughlin

Mid 2010 Macbook Pro. I used a zip tie as suggested in previous post - worked great. Zip tie is connected by existing screws. (1) Choose zip tie wide enough to fit screw holes. Measure and cut the zip tie to approximate length from screw 1 (lower right) to screw 2 (upper left). You will trim this later. Mark on zip tie where to place first hole (lower right screw). (2) Use ice pick to create hole in zip tie - this takes a bit of back and forth to get it to match the screw thread size. (3) Screw the first screw into the zip tie and then into the socket. Mark zip tie where 2nd screw hole is to be made. (4) Remove first screw (and zip tie) and then make hole for 2nd screw. I made the hole just a little smidge lower down the zip tie to give extra tightening across ram. (5) Note: 2nd screw thread is smaller diameter so don’t make that hole as big as the first one. (6) Screw in both screws to the zip tie first and then they are held in place when you screw into the sockets. Screw each into sockets. (7) Use...