Инструкции с моим вкладом
Этап 1 из 3
Are the 2013, 2014 and 2015 motherboards interchangeable?I have a 2014 13" Macbook Air that needs a new mobo, and it appears that the 2013 and 2015 motherboards might be...
Ответ на "Console message en3 promiscuous mode enable succeeded"This likely indicates a graphics chip failure and need for a new motherboard. Very common in the 2011 Macbook Pro series, but apparently also affects some retina display models too. Repair extension from Apple https://www.apple.com/support/macbookpro-videoissues/ Sadly they no longer repair the 2011’s.
Ответ на "SMC reset without power button"It is not a total reboot, it just turns on the machine. That said, unplugging the battery and the power for a bit (30 mins?) should accomplish an SMC reset.
Ответ на "Can I replace the original drive with a SSD?"The Accepted Answer refers to a post which replaces the optical drive with an SSD so that the iMac has both an SSD and HDD. To answer your question, there is no 3.5" SSD drive form factor. What you want is a 2.5" SATA SSD, which you will place in a 2.5" to 3.5" adapter. Because of the length of the cables, you want one that won't just hold the drive in place but puts the connections where they belong, such as the Icy Dock EzConvert.
Ответ на "HDD with an SSD in a 2009 iMac?"Good catch, looks like I misread the original post. I was responding to the sentence "In order to put a SSD into an iMac that isn't a 27" or a 2011 21.5" then you need a optibay." This is true only if you wish to retain the original HDD, which was the case, but as I said, I misread the somewhat awkwardly worded original post. That said, prices for 512GB SSDs are getting near $200 these days and will continue to fall. Considering the speed increase and reliabilty of SSDs vs HDDs, I am finding it harder to justify the cost savings of HDDs lately.
Ответ на "Replace A1286 Mid 2009 Logic board with a mid 2010 one?"The top case is a bit different as well. The are screw holes for the subwoofer on the 2010 which the earlier model lacks, and the bluetooth antennae on the 2010 has a piece of metal that looks like it attaches to the frame (glued?). The older model has a thin black plastic material covering that area (which appears to be cut away on the newer one, but I couldn't find any info on removing it and didn't want to mess it up so I left it in place. HTH someone.