Hi Nick As Christian said it will be very very hard if it is more than a top and bottom layer and how much money do you want to spend finding out? But Nice! I like these types of repair, so fulfilling when you get it done Now lets assume it is a part of the board that only has a top, or and bottom tracers You can get "Wire glue" eBay. You will need a magnifying glass and a steady hand and get creative it can be done if the phone is worth it to you
Hi Deborah Sounds to me from your description of the fault that the screen is faulty and you need to replace it, mind you this is only one of the reasons, there are others. But this is going to be the cheapest to fix I'm thinking Look at the guides to this repair all the info is right here, go through them a couple of times before you attempt the repair Good luck
Hi Aaron OK I recon you should step back and think about this. NUMBER ONE: Disconnect the battery 2.Very gently remove your screen from there connectors again 3.Find all the screws now if you have done this, it sounds to me that the screen is not seated on the connectors correctly (we have all done that). It is so important that you take your time, you sound as if you don't do this often so slow down :) Have you got a magnifying glass if not go get one, if so check each connector for damage Check your ribbon cables, on the new screen for damage..... no damage good Right then if you can't see any damage start to re connect the screen to the connectors on the board, now don't go at it like a bull at a gate , slow and gentle is going to win this race, be on a flat surface and each time you seat a connector check it, make sure it is fully inserted (flat) into the connector "take your time" Do this with the rest of them, it could take a couple of goes but be patient and it will work Last and most important...
Hi mate, after water damage it most times kills the screen, replace it. Or if you can, test that screen on a known good phone unless you want to go to the extreme first of stripping down the phone and Searching the main board for blown components, if you have the tools and the ability, cool, if not its a big job ! The screen is your starting point Cheers