Canon Powershot SD880 Troubleshooting

Camera won't turn on ¶ 

No matter what you do, the camera will not turn on.

Drained/Damaged battery ¶ 

The battery may need charging or replacing.

Bad logic board ¶ 

The logic board is not working properly and needs to be replaced.

Disassembling Canon Powershot SD880 Logic Board

Lens is stuck ¶ 

The camera lens does not move to focus or retract.

Dirty lens-opening mechanism ¶ 

Particles may be caught inside the lens chamber. Clean with a soft dry cloth. Check the dis-assembly guide for hard-to-reach areas.

Broken lens ¶ 

The lens itself may be broken. It needs replacement.

Function buttons do not respond ¶ 

The buttons on the camera do not respond.

Menu pad is broken ¶ 

If the menu pad next to the display does not respond, the pad will need to be replaced.

Top panel does not work ¶ 

If the buttons on top of the camera do not respond, it may need to be replaced.

Display does not show proper image ¶ 

Nothing shows on the screen or the image is distorted.

LCD is not connected properly ¶ 

Check the connections to make sure that they are properly placed.

Disassembling Canon Powershot SD880 LCD Display

LCD is broken ¶ 

If the screen is broken, then it will need to be replaced.

Flash does not work properly ¶ 

The camera's flash does not work.

Flash setting is off ¶ 

Check to make sure the flash setting is on before assuming that there is a problem.

Low battery ¶ 

Battery may be too low for flash use. Recharge battery and check if flash works.

Broken flash unit ¶ 

The flash itself may be damaged. If so, the unit will need to be replaced.

Disassembling Canon Powershot SD880 Flash

Battery/Memory card slot not working ¶ 

The battery and/or memory card do not properly fit into their respective slots.

Broken Battery/Memory card slot ¶ 

If the battery and/or memory card does not easily slide into their slots, or the camera does not register that they are connected, the slot should be replaced.

Один комментарий

When I turn it on the green light in back flashes for about 10 seconds and then the back panel displays “lens error, restart camera”. Everything else seemed to be working fine up until this started happening. Easily fixable?

Scott Hoffman - Ответить

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 3

За всё время: 2,474