Перейти к основному содержанию

A washer series by Maytag with a low rate of customer satisfaction and a high rate of failure. These washers have the model numbers MVWB300xxx or MVWX300xxx.

213вопросов Показать все

Squeaking noise when start up on Maytag Bravos Quiet Series 300 dryer?

The dryer is squeaking when beginning a cycle

After it is warmed up or in use for a few minutes it seems to not be as bad

Is there an easy troubleshooting method?

Could it be a bearing or is it a belt?

Where do I begin?

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Оценка 6
Добавить комментарий

2 Ответов

Наиболее полезный ответ

I find your photos of a repair on a GE dryer interesting, but this is not the same design as the Maytag (Whirlpool) dryers. The Bravos 300 series are very similar to the Maytag Neptune series.

To replace the two wheels (located inside the rear of the dryer) on which the dryer drum rides - these do wear out depending upon frequency of machine use and size/weight of the loads. The front of the Maytag machine must be removed, then slide the drum out, and use a ratchet with socket to remove the two wheels with their holding bolt. A kit containing all the necessary parts can generally be purchased through an appliance parts center for about $40-50. Be sure to have your model number when ordering/purchasing the parts.

Был ли этот ответ полезен?

Оценка 2
Добавить комментарий

It's probably a worn out drum bearing. Here's a pictorial guide on replacing one: http://marksprojects.wordpress.com/2009/...

Был ли этот ответ полезен?

Оценка 1
Добавить комментарий

Добавьте свой ответ

rick будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 5

За последние 30 дней: 13

За всё время: 16,975