Репутация: 13
2
So just as the description says, when putting one of the hex screws back in on the antenna plate, I over tightened and stripped one of the screws. And when I say stripped, I mean I stripped the threads, the screw just spins now and doesn't hold, it just falls out. Is there any solution for this?
Это хороший вопрос?
Репутация: 209
7
1
Usually it's possible to grab the screw with a pair of needled nose pliers. If not, you might have to drew the screw out using a drill.
Hope it helps!
Был ли этот ответ полезен?
Репутация: 229
6
3
There's some really cool pliers designed for just this problem!
Был ли этот ответ полезен?
Its not the hex part thats stripped, its the threads female threads that are stripped.
To get it to hold back in place, you can always try using some Loctite or another type of threadlocker. Just don't get the super high strength stuff, or you'll do more damage.
Thats kind of what I was thinking...Guess I'll give that a shot.
Were you able to solve it? I have the same problem
За последние 24часов: 2
За последние 7 дней: 6
За последние 30 дней: 9
За всё время: 408
1 Комментарий
Were you able to solve this problem? I'm having the same issue
из Discostu75