Репутация: 13
1
In the process of removing the logic board the power switch cable was unintentionally ripped from the back of the power switch. Is there any way to remove the switch so I can attempt to resolder the wire to the switch?
Это хороший вопрос?
Репутация: 685,6к
3,4к
1,1к
2,6к
That switch is usually held in place by 3 plastic globs that are integrated into the back frame. I have used a chisel to break them off and then re-glued it back into place after replacing. It not a pretty repair, just a hack.
Был ли этот ответ полезен?
This answer is not a very good It is very silly
Well Manuel, just how do you proposed to repair it? Have you even looked at one?
За последние 24часов: 0
За последние 7 дней: 0
За последние 30 дней: 0
За всё время: 232
1 Комментарий
Did this solution work? I have the same problem. Any tips?
из kbranch