Репутация: 13
1
I did 4 loads of laundry without issue, i loaded the washer for the 5th load and realized the machine was dead, no lights, nothing. The outlet was working fine but the machine shows no signs of life. Any thoughts? Is there some sort of internal breaker that may tripped?
Это хороший вопрос?
Репутация: 685,4к
3,4к
1,1к
2,6к
Line Fuse
The line fuse blows if the washer circuits are overloaded. If the line fuse blows, the washer won’t start. To determine if the line fuse is at fault, use a multimeter to test it for continuity. If the fuse does not have continuity, replace it. In addition, you should investigate and resolve the problem that caused the fuse to blow. Check for shorted out components such as the wires, motor, or drain pump. If you don’t resolve the underlying issue, the new fuse will blow too.
Был ли этот ответ полезен?
I can't seem to find the fuse, can you tell me where it's located? all the electronics seem to be on top but i don't see a fuse
Please give us your model number.,
Model #79640272900 (kenmoore)
There does don't seem to be a fuse for your model. Check the main breaker and reset it. That failing test the wall plug with a multimeter. If you have power we can look t other possible causes.
I have the same problem on a Kenmore 600s any idea where the fuse is?
Same issue but pulling plug or trip circuit breaker for +10 seconds and reset and machine functions fine. This is a temporary fix.
What is wrong or failed????
Был ли этот ответ полезен?
I have the same issue. If I unplug the machine for 10 seconds or more, them plug it back in, it works fine for one cycle. Then back to unplug, reset, etc. What's failed in the machine?
За последние 24часов: 1
За последние 7 дней: 8
За последние 30 дней: 71
За всё время: 13,151
1 Комментарий
My cycles will not light up for selection. When I press and hold the drain/spin button I do get a light after the 3 seconds of holding. I am at a loss why nothing else will light up. I have checked that the door shuts tight as well. Any thoughts?
из laurie