I was updating my G Priv 1 and while the update software was installing, the the program went unresponsive and I had to force close it. Now my G Priv won't turn on and my computer won't recognize the usb device. Is the mod totally bricked or is there a way for me to revive it?
Это хороший вопрос?
Репутация: 1,3к
15
7
2
Hey David,
Unfortunately, if the device is disconnected while updating firmware/software, it usually bricks the device, unless you would like to lean microsoldering. If you would, I would reccomend watching these videos, or these ones. Also, check out this guide. Sadly, I faced a similar problem with a $50,000 laser engraver. Luckily, it was only $800 dollars to replace some parts, but in your case, I don't know if it will be that easy (but much cheaper!).
Hope this helps,
-Tanner
Был ли этот ответ полезен?
За последние 24часов: 0
За последние 7 дней: 1
За последние 30 дней: 7
За всё время: 718
