Почините Свои Вещи Сообщество Магазин

Repair guides and support for LED, LCD, HD and other Vizio TVs.

932вопросов Показать все

Опции

D55u-d1 Gets logo then powers off.

So of course my Vizio TV is out of warranty. Recently I have an issue where the logo will display but after 10 seconds it powers off. Being out of warranty I replaced the main board myself to no avail. Before I waste more money solving this problem does anyone have any ideas as to what would cause this problem?

All the boards look good, I don't see any signs of blown capacitors, I'm just wondering what my next step should be, replace power board or replace t-con board.

Vizio tells me it can't be a firmware issue nor will they release the firmware to me.

Any ideas?

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Да Нет
Оценка 0

1 Комментарий:

After talking to tech support from their third party company it sounds like a screen issue....if that's the case it's not cost effective to fix. Anyone else dealt with a power issue on screen itself?

из

Добавить комментарий

3 Ответов

Фильтр:
Самые полезные Самые новые Самые старые

Опции

If you change the logicboard , then check if there is any other board inside, then check for the backlight if it works.

Был ли этот ответ полезен?

Да Нет
Оценка 0

3 Комментариев:

Backlight works I can see it power on with the back panel open. There are 3 other boards, but I found a total repair kit for $70 that includes all the boards, so I just bought it. I'll regut the whole thing and that should solve any issues I'm having.

Thanks,

Dan

из

Alright, if you change it all and not work there is no other way

из

lol that would be my luck!! Vizio support is no help.....they make it sound like only absolute trained professionals should replace these parts.....sorry Vizio your LED tv's are much easier to fix than the 5 DLP's i've brought back to life!

из

Добавить комментарий

Опции

Regutted entire TV, nothing solved the problem....i'm believing it's a firmware issue yet no one will release the firmware to me....anyone happen to know where I could get it?

Был ли этот ответ полезен?

Да Нет
Оценка 0

1 Комментарий:

Did you figure out the solution?

из

Добавить комментарий

Опции

You have a bad EEPROM in the main board, its what sends the start boot to the CPU, its a common failure, and a $10 part but a little tricky to replace unless you are real good at soldering, its only a 8 pin chip but very small, a replacement main board will also fix the issue but that board isn’t cheap

Был ли этот ответ полезен?

Да Нет
Оценка 0

1 Комментарий:

Do you know the part number?

из

Добавить комментарий

Добавьте свой ответ

Dan Ritchie будет вечно благодарен.
Просмотр статистики:

За последние 24часов: 2

За последние 7 дней: 5

За последние 30 дней: 16

За всё время: 1,156