Репутация: 13
2
1
See photo:
This is a connector for an Ipad Pro charging port. I am replacing this however, when I took the old one off half of this pad came off..
Can I solder to this pad with majority of it gone or do I have to run a jumper? I am just learning so please have some mercy. Thank you!
Это хороший вопрос?
Репутация: 782,3к
1,1к
893
2,3к
@smitty1510 yes you can but you better be good at it. No room for fudging and you only have one chance.
Был ли этот ответ полезен?
@oldturkey03 I need to run a jumper... No schematic or BV available for this model. Not on ZXW either... Any Ideas? How can I find out where to run the jumper?
@smitty1510 there is no way unless you have the schematic.
За последние 24часов: 0
За последние 7 дней: 0
За последние 30 дней: 3
За всё время: 108
