Опции

Won't power on, replaced DC-In board

I had the same problem with the scalding hot MagSafe, but I must've killed something in my Mac, because now it won't turn on.

I replaced the DC-In Board and am not seeing the light on my power adapter light up at all.

I've used two different power adapters with the same result. When I did replace the DC-In Board, I failed to connect the keyboard ribbon because I didn't have the battery's ridiculous Tri-Wing Drivers. What would be the next logical step in order to get the device to turn on?

I'm ordering the tools I need for the battery so I can connect the keyboard, but would that even matter for booting the Mac?

Do I need to replace the Logic Board?

Отвечено! Посмотреть ответ У меня та же проблема

Это хороший вопрос?

Да Нет

Оценка 0

Добавить комментарий

Опубликовано: 26 мар 2019 г.

Опции

See if the DC-in Board pins 2&4 (2nd from either side). Magsafe connector 2&4 pins are pressed down and not fully popped out. Hence these pins while touching DC-in Board connector, do not make full contact. They are making loose contact which in turn makes arcing/sparking which generates heat to make Magsafe hot. Use a wooden toothpick to depress and release them. It is a typical phenomenon you see on household electric plugs getting fused and burnt. I suggest you clean both sides with alcohol and there is high chance that it should be working good.

Был ли этот ответ полезен?

Да Нет

Оценка 3

Добавить комментарий

MacBook Pro 15" Unibody Mid 2009

Won't power on, replaced DC-In board

1 ответ

Добавьте свой ответ