Major components (bottom cover, battery, wheels, brush assembly) are easy to remove & replace. However, I believe I need to clean connections at the main board below the top cover to repair my Roomba. I don’t see an obvious way to get the cover off. Any help?
Это хороший вопрос?
Репутация: 783,9к
1,1к
894
2,3к
@potterra you need to remove the bumper. Then disconnect the ribbon cable from the bumper before you remove it completely. Take a look at this video and use that as a general guide since it is not the same model as yours.
Был ли этот ответ полезен?
За последние 24часов: 0
За последние 7 дней: 0
За последние 30 дней: 16
За всё время: 160
