iPhone SE 2020, restarting every 180s because of tg0b, board defect?

Question

iPhone SE 2020

Всё, что нужно знать о ремонте и разборке iPhone SE второго поколения, который был выпущен в апреле 2020 года.

243вопросов Показать все

benjemiah @benjemiah

Репутация: 25

3

Опубликовано: 26 июл 2022 г.

Опции

iPhone SE 2020, restarting every 180s because of tg0b, board defect?

Hello Guys, i need help. I have an iPhone SE 2020, replaced screen (by me) which is now kernel panicking and restarting every 180s (has nothing to do with the kernel panicking, screen replacement was done now a year ago). It has no obvious pry damage, the mosfet by the battery connector is still in place and not moveable. With both the OEM Battery and a new 3rd party one the kernel panic keeps happening as well as the 0% battery charge thing. In the logs "missing tg0b" is stated. When starting without the dock and front camera flex attached the logs state "missing tg0b and mic1", so i suppose its a board issue? Any tips?

The battery connector

Ответ на этот вопрос У меня та же проблема

Это хороший вопрос?

Да Нет

Оценка 1

1 Комментарий

One of the data pins looks to be pushed into the plastic but I cannot be certain. The measurements you took are okay.

26 июл 2022 г. из Chris Stables

Добавить комментарий

3 Ответов

One of the data pins looks to be pushed into the plastic but I cannot be certain. The measurements you took are okay. — Chris Stables

Chris Stables @imicrosoldering Репутация: 50,7к 8 14 101 · Answer 1 · 2022-07-26T15:32:59-07:00

Наиболее полезный ответ

Chris Stables @imicrosoldering

Репутация: 50,7к

8

14

101

Опубликовано: 26 июл 2022 г.

Опции

This does sound like a battery data problem. The first thing to check would be the battery connector as they are known to be problematic on this model. Check the pins have not been pushed into the plastic, if they have you will need to pry them out. The next step would be measuring the pins with a multimeter in diode mode. Also there are two fetts near the battery connector not just one.

Был ли этот ответ полезен?

Да Нет

Оценка 1

1 Комментарий:

i measured the pins and got the following readings: GND for GND and 418 for the 2 big pads on the other side as well as 689 for the data pins. Ill post in another comment a picture of the connector

26 июл 2022 г. из benjemiah

Добавить комментарий

Dhayalan Selvan @ds17 Репутация: 1 4 · Answer 2 · 2022-07-26T06:06:52-07:00

Dhayalan Selvan @ds17

Репутация: 1

4

Опубликовано: 26 июл 2022 г.

Опции

Hi Benjemiah,

The error code refers to Temperature monitoring chip on the motherboard stopped working due to no feedback from the temperature sensor it has gone to fail safe mode (restart for every 3 mins)

Был ли этот ответ полезен?

Да Нет

Оценка 0

1 Комментарий:

So it is not a Battery SWI Problem? How can it be fixed?

26 июл 2022 г. из benjemiah

Добавить комментарий