Перейти к основному содержанию

Введение

Prerequisite-only guide to slide the logic board and attached components out of the Mac mini's chassis.

  1. Grasp the power supply cable and lift to disconnect it from the logic board, wiggling as needed to loosen it up.
    • Grasp the power supply cable and lift to disconnect it from the logic board, wiggling as needed to loosen it up.

  2. Carefully lift the connector for the LED indicator light straight up to disconnect it from its socket on the logic board. Take care not to pry under the socket, or you may break it off the board.
    • Carefully lift the connector for the LED indicator light straight up to disconnect it from its socket on the logic board.

    • Take care not to pry under the socket, or you may break it off the board.

  3. Use a T10 Torx driver to remove the two 7.5 mm screws securing the logic board. Use a T10 Torx driver to remove the two 7.5 mm screws securing the logic board.
    • Use a T10 Torx driver to remove the two 7.5 mm screws securing the logic board.

  4. In this step, you'll push the logic board free from the clips holding it to the frame. Push only where directed or you may damage the fragile cooling fins. Place a thumb at each end of the exhaust vent, over the fan screw holes. Push firmly in the direction of the ports until the logic board unclips and begins to slide out of the Mac mini.
    • In this step, you'll push the logic board free from the clips holding it to the frame. Push only where directed or you may damage the fragile cooling fins.

    • Place a thumb at each end of the exhaust vent, over the fan screw holes.

    • Push firmly in the direction of the ports until the logic board unclips and begins to slide out of the Mac mini.

  5. Slide the logic board out of the case. When reinstalling the logic board, make sure to hold the thin LED indicator light cable out of the way so it doesn't get damaged.
    • Slide the logic board out of the case.

    • When reinstalling the logic board, make sure to hold the thin LED indicator light cable out of the way so it doesn't get damaged.

Заключение

To reassemble your device, follow these instructions in reverse order.

Jeff Suovanen

Участник с: 06.08.2013

247 943 Репутация

Автор 212 руководств

Команда

iFixit Member of iFixit

Community

104 членов

Автор 9 250 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 1

За 30 дней: 8

За всё время: 60