Введение

We all know that the Sega Genesis brought to us many hours of fun, but, as we get older, the reset button gets older too.

Today, let's lend a hand to our nice friend and replace its reset button!

Запчасти

Никакие детали не требуются.

  1. Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
    • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

  2. Flip the Sega Genesis upright.
    • Flip the Sega Genesis upright.

    • Gently lift the top casing.

    • Note: the case will be connected to the main board by LED wires.

    • Bend out the LED leads into vertical positions.

    • Slide the LED wire apparatus off the lead pins.

    • Note: observe which color wire corresponds with which length of pin.

    • Separate the main board from the outer case.

    • Using Philips screwdriver, remove 11 screws securing silver casing.

    • Remove silver case.

    • Locate reset button on motherboard

    • Place three pieces of 1cm x 1cm masking tape over reset button.

Заключение

To reassemble your device, follow these instructions in reverse order. And the most important, be happy!

One other person completed this guide.

calvin

Участник с: 05.10.2010

195 Репутация

1 Guide authored

Команда

Cal Poly, Team 3-29, Regan Fall 2010 Member of Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 членов

Автор 5 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 5

За 7 дней: 20

За 30 дней: 114

За всё время: 11,686