Выберете то, что вам нужно
-
-
Flip the mouse over and peel off the stickers on the perimeter of the bottom of the mouse.
-
-
-
Use the Phillips #1 screwdriver to remove four 5 mm screws from the bottom of the mouse.
-
Use the Phillips #1 screwdriver to remove the two 9 mm screws from the bottom of the mouse.
-
-
-
-
Touch your capacitor discharge tool to the capacitor leads on the board to release the stored energy. If leads are inaccessible, wait until you've removed the board from the mouse body.
-
-
-
Use a spudger to pry underneath the white plug and pop it out to disconnect the upper board from the lower board.
-
-
-
Remove the 5 mm round head screw holding the middle piece to the top piece.
-
The outermost shell will now separate from the middle structure.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
3 участников успешно повторили данное руководство.
Команда
Cal Poly, Team 18-36, Regan Winter 2013 Участник Cal Poly, Team 18-36, Regan Winter 2013
CPSU-REGAN-W13S18G36
3 членов
Автор 30 руководств
