Почините Свои Вещи Сообщество Магазин

Возврат к шагу #5

Отредактированно Arthur Shi -

Правка одобрена автор Arthur Shi

До
После
Без изменений

Шаг Линий

-[* black] Peel the adhesive off the back of the small temperature probe board.
-[* black] Attach the temperature probe board onto a metal surface area of the SSD, close to the connector ports.
-[* black] Fold the excess temperature probe wires out of the way.
+[* black] Peel the backing off of the adhesive back of the small temperature sensor board.
+[* black] Adhere the temperature sensor board to an exposed, metal area of the surface of the SSD, as close as possible to the SATA ports.
+[* black] Fold the excess temperature sensor wires so that they are out of the way while you install the enclosure.