Перейти к основному содержанию

Возврат к шагу #7

Отредактированно johnsawyercjs -

Правка отклонена автор Arthur Shi

До
После
Без изменений

Шаг Линий

[* red] Remove the twelve 4.2 mm Phillips screws securing the LCD assembly to the rear display bezel.
[* icon_note] Make sure you pay attention to how the microphone cable (and antenna cable on some models) are routed around the outside of the two screws nearest to the bottom of the screen (on both left and right). It's easy to damage the cables if not routed properly when putting these screws back on.
+[* icon_note] To better see the routing for the cables around the lower left and right corners of the display, click on the photo of the display in this step, which will open a higher-resolution version of the photo in a new tab, where you can click on this photo to magnify it so you can see the cable routing in the corners in larger detail.