Перейти к основному содержанию

Rimozione gruppo pannello anteriore

Примечание: Вы редактируете необходимое руководство. Любые внесённые вами изменения влияют на все 12 руководства, которые включают этот шаг.

Английский
Итальянский

Перевод шага 7

Шаг 7
Front Panel Assembly Removal, Remove the front panel assembly: шаг 0, изображение 1 из 3 Front Panel Assembly Removal, Remove the front panel assembly: шаг 0, изображение 2 из 3 Front Panel Assembly Removal, Remove the front panel assembly: шаг 0, изображение 3 из 3
Remove the front panel assembly
  • Remove the front panel assembly.

  • Use an opening pick to cut away any residual adhesive that may still be connecting the front panel assembly to the frame.

  • If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as Kapton (polyimide) tape, to the highlighted areas on the back of the panel. iFixit replacement digitizers come with the proper insulation and should not require the addition of any tape.

  • Without the proper insulation, these areas of the digitizer can ground out against other components, causing touch input malfunction.

  • The insulation is not visible to the naked eye, and is different from the foam dust barrier strips found on many iPads.

  • During reassembly, before installing a display, remove any remaining adhesive from the iPad, and clean the glued areas with high concentration isopropyl alcohol (90% or greater) and a lint-free cloth. This helps prep the iPad for fresh adhesive and ensures that it will bond properly.

  • Test your iPad's functions and install pre-cut adhesive strips to the back of the display using our display adhesive application guide before sealing it up.

Rimuovi il gruppo del pannello anteriore.

Usa un plettro per tagliare l'adesivo rimasto che potrebbe tenere ancora insieme il gruppo del pannello anteriore e la cornice.

Se riscontri dei tocchi "fantasma" con il tuo nuovo schermo, potrebbero venire risolti aggiungendo uno strato di un nastro isolante molto sottile, come il nastro Kapton, nelle aree evidenziate sul retro del pannello anteriore. I digitizer di ricambio iFixit hanno l'isolamento necessario e non dovrebbero richiedere altro nastro.

Senza l'isolamento adeguato, queste zone del digitizer possono fare corto circuito con altre componenti, causando dei malfunzionamenti dell'input dei tocchi.

L'isolamento non è visibile ad occhio nudo, ed è diverso dalle strisce protettive in polvere di schiuma che si trovano in molti iPad.

Durante il rimontaggio, prima di installare lo schermo, rimuovi tutto l'adesivo rimasto dall'iPad, e pulisci le zone di adesione con dell'alcool isopropilico ad alta concentrazione (>90%) ed un panno senza lanugine. Questo aiuta a preparare l'iPad per il nuovo adesivo ed assicurare che faccia presa correttamente.

Prova la funzionalità del tuo iPad ed applica delle strisce adesive pretagliate sul retro dello schermo seguendo la nostra guida sull'applicazione dell'adesivo dello schermo prima di richiuderlo.

Ваш вклад лицензируется под свободной лицензией Creative Commons .