Перейти к основному содержанию

Примечание: Вы редактируете необходимое руководство. Любые внесённые вами изменения влияют на все 5 руководства, которые включают этот шаг.

Английский
Японский
Шаг 2
This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue. If you're installing a new front panel assembly, it may need the following preparation:
Front panel preparation
  • This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue.

  • If you're installing a new front panel assembly, it may need the following preparation:

  • Peel the large clear plastic liner off of the inside of the glass.

  • Peel any blue plastic backings covering the adhesive around the perimeter of the front panel assembly.

  • Once removed, the adhesive strips will be exposed. Don't remove these backings until you're ready to install the front panel assembly.

  • Don't remove any copper coverings from the outlined region, such as yellow kapton tape or black electrical tape.

  • Ensure the glass panel is free of fingerprints and grime before installing it on your device.

新しいフロントパネルアセンブリに付け替える場合、次の準備が必要です。

正面パネルアセンブリの周囲の接着剤をカバーしているプラスチックストリップを剥がしてください。

デジタイザーケーブルから小さい接着剤シールを取ります。

全ての銅パーツが新しい交換スクリーン上で覆われていることを確認してください。もし覆われていない場合は、スクリーンがばらばらに動いてしまいます。

-[* icon_note] If you're installing a new front panel assembly, it may need the following preparation:
- [* red] Peel the plastic strips covering the adhesive around the perimeter of the front panel assembly.
- [* orange] Remove the small piece of adhesive backing from the digitizer cable.
-[* black] Make sure all copper is covered on the new replacement screen as once fitted without this the screen will move randomly.
+[title] Front panel preparation
+[* icon_reminder] This is a good time to power on your iPad and test all functions before you seal the display in place. Be sure to power your iPad back down completely before you continue.
+[* icon_note] If you're installing a new front panel assembly, it ***may*** need the following preparation:
+ [* red] Peel the large clear plastic liner off of the inside of the glass.
+ [* orange] Peel any blue plastic backings covering the adhesive around the perimeter of the front panel assembly.
+ [* icon_caution] Once removed, the adhesive strips will be exposed. Don't remove these backings until you're ready to install the front panel assembly.
+ [* yellow] ***Don't remove any copper coverings from the outlined region***, such as yellow kapton tape or black electrical tape.
+[* black] Ensure the glass panel is free of fingerprints and grime before installing it on your device.

Ваш вклад лицензируется под свободной лицензией Creative Commons.