Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Английский
Испанский

Translating step 1

Step 1
Carefully remove the rubber fan bumper from the edge of the heat sink. The fan bumper wraps around the heat sink and fits into the fan duct slots. During reassembly, be sure to fit the tabs into the notches in the fan duct. The fan bumper wraps around the heat sink and fits into the fan duct slots. During reassembly, be sure to fit the tabs into the notches in the fan duct.
  • Carefully remove the rubber fan bumper from the edge of the heat sink.

  • The fan bumper wraps around the heat sink and fits into the fan duct slots. During reassembly, be sure to fit the tabs into the notches in the fan duct.

Cuidadosamente remueva el hule absorvente de impactos del ventilador desde el borde de el disipador de calor.

El hule absorvente de impactos se envuelve alrededor del disipador de calor y encaja en las ranuras del ducto del ventilador. Durante el reensamblaje, asegúrese de colocar las lengüetas en las muescas del conducto del ventilador.

Ваш вклад лицензируется под свободной лицензией Creative Commons.