Перейти к основному содержанию

Примечание: Вы редактируете необходимое руководство. Любые внесённые вами изменения влияют на все 2 руководства, которые включают этот шаг.

Английский
Французский
Шаг 31
Remove the battery isolation pick. Insert a plastic card underneath the logic board at the battery connector. Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.
  • Remove the battery isolation pick.

  • Insert a plastic card underneath the logic board at the battery connector.

  • Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.

  • As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in Step 60. Position the card exactly as shown.

  • Slide the card all the way underneath the logic board, separating the adhesive along the outer edge.

Retirez la médiator d'isolement de la batterie.

Insérez une carte en plastique sous la carte mère, au niveau du connecteur de la batterie.

Lorsque vous faites céder l'adhésif sur le bord extérieur de la carte mère, faites attention de ne pas endommager la nappe de l'ensemble bouton supérieur, que vous avez débranchée lors de l'étape 60. Placez la carte exactement comme sur la photo.

Faites glisser la carte tout le long de la carte mère, pour faire céder l'adhésif le long du bord extérieur.

[* black] Remove the battery isolation pick.
[* black] Insert a plastic card underneath the logic board at the battery connector.
[* icon_caution] Do not use excessive force when inserting this card under the logic board to prevent damaging its battery pins. If the logic board wont budge easily, try reheating the adhesive underneath with an iOpener.
[* icon_caution] As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in [guide|63740|Step 60|stepid=134002]. Position the card exactly as shown.
[* black] Slide the card all the way underneath the logic board, separating the adhesive along the outer edge.

Ваш вклад лицензируется под свободной лицензией Creative Commons.