Опции

What do I replace the original thermal materials with?

I am reinstalling my recently repaired logic board in my G3 900mhz iBook 14". The original thermal heat transfer materials on the heat sink were two preformed squares, the larger was a blue foam looking square, the other smaller one was gray and seemed to be a more solid version and consistency of thermal paste. Can I use the normal Arctic Silver paste for the installation or do I need to find the same type of original squares?

Thanks,

Randy

Отвечено! Посмотреть ответ У меня та же проблема

Это хороший вопрос?

Да Нет

Оценка 2

2 Комментариев

Good question +

6 авг 2010 г. из rj713

Thank you, I'll give that a go.

Randy

6 авг 2010 г. из randy3833

Добавить комментарий

Опубликовано: 6 авг 2010 г.

Опции

Arctic Silver Thermal Paste will work great om the heat sink in your laptop.

Был ли этот ответ полезен?

Да Нет

Оценка 2

2 Комментариев:

Thanks. Do you have a recommendation for the thickness of the paste? The iFixit instructions say to spread a thin layer. The original materials were fairly thick, maybe up to 1/16th of an inch.

6 авг 2010 г. из randy3833

My experience in the matter is that it's better to have a bit too much than a bit too little. You just really need to make sure you don't have any that comes out over the edges / spills out when you reapply the heat sink. 1/16 " sounds fine to me, I just like to make sure I can't see the processor any more through the thermal compound.

6 авг 2010 г. из Taylor Arnicar

Добавить комментарий

iBook G3

What do I replace the original thermal materials with?

1 ответ

Добавьте свой ответ