Репутация: 43
4
1
After completing a digitiser replacement, when laying down the glass, it does not sit flush with the frame of the device. It rises up slightly where the cables are, and no matter what I try, I cannot get it to sit flush. A picture of where the cables are sat now is attached.
Это хороший вопрос?
Репутация: 221,5к
15
290
807
It’s hard to tell from your picture but it appears that the flex on the digitizer hasn’t been adhered properly. Take a look at this image (Step 37) from this guide. Also look at the old digitizer for reference. The rest of the flex is bent over on itself and adhered to the back of the digitizer.
There should only be the two narrow flexes going from the digitizer to the logic board.
Был ли этот ответ полезен?
Ah yes that’s probably it, I’ll try that tomorrow
За последние 24часов: 0
За последние 7 дней: 1
За последние 30 дней: 7
За всё время: 80
