Shot in the dark for Hall Sensor for Culligan
I have a Culligan Gold series watersoftener. My unit can measure water flow. The way it does this is through a hall sensor that measures a small impeller that spins as the water flows. There is a magnet in the impeller that is read by the hall sensor.
I have tested the sensor by digging it out of it's epoxy bed and injecting 5 volts, it seem to be bad. I can't read any markings on the sensor. I don't know if it's a north or south sensing. (I don't know anything about hall sensors, only what I have learned in the last few days. I want to solder in a new sensor. It's about 4mm wide.
Это хороший вопрос?