RA1165 Under-Table Router Base Operating/Safety Instructions (EN, FR, ES)

IMPORTANT

Lire avant usage

IMPORTANTE

Leer antes de usar

心

Operating/Safety Instructions

Consignes d'utilisation/de sécurité

Instrucciones de funcionamiento y seguridad

RA1165

7

H

BOSCH

Call Toll Free for Consumer Information and Service Locations

Pour obtenir des informations et les adresses de nos centres de service après-vente, appelez ce numéro gratuit

Llame gratis para obtener información para el consumidor y ubicaciones de servicio

1-877-BOSCH99 (1-877-267-2499) www.boschtools.com

For English Version

See page 2

Version française

Voir page 6

Versión en español

Ver la página 10

⊕

WARNING Read and understand these instructions, tool manual, and router table manual for use of these accessories. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.

△WARNING Disconnect the plug from the power source before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

⊕

SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE

The RA1165 Under-Table Router Base is designed only for use with Bosch 1617/18 Series router motors.

Assembly and Installation

▶ Attaching Base To Mounting Plate

Attach the RA1165 to the router table's mounting plate using either or both sets of enclosed mounting screws.

The base has two sets of threaded holes for mounting the base:

• Three 10-24 holes in industry-standard 3-hole pattern.

Four M4 holes in Bosch 4-hole pattern.

Included mounting screws for the RA1165:

• Three 10-24 x 3/4" screws.

• Four M4 x 20 mm screws.

If your router table mounting plate does not have countersunk holes in either of those patterns, you will need to determine the hole locations, drill and countersink them, also locate and drill a hole for the over-table adjustment wrench.

Note: Because each of the holes in the Bosch 4-hole pattern goes all the way through the base, it is easier to use it as a template for marking the mounting plate for drilling, than is the 3-hole pattern (which has one hole that does not go all the way through the base).

The RA1165 should be positioned so that its quick-release clamp lever and depth adjustment controls face the front of the router table (Fig. 1).

Once the mounting plate has suitable countersunk mounting holes, attach the RA1165 using one or both of the attachment screw sets with a no. 2 Philips screwdriver.

Installing The Mounting Plate In The Router Table

Follow the instructions in the router table's owner's manual.

Installing Motor

The motor can be installed with the switch facing left or right. It is best to orient the motor's on/off switch (and speed control on the 1617EVS or 1618EVS motors) on the RA1165 so that