WARNING

Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or

Electrical Shock Hazard electrical shock.

IMPORTANT

Electrostatic Discharge (ESD) Sensitive Electronics

ESD problems are present everywhere. ESD may damage or weaken the electronic control assembly. The new control assembly may appear to work well after repair is finished, but failure may occur at a later date due to ESD stress.

• ■ Use an anti-static wrist strap. Connect wrist strap to green ground connection point or unpainted metal in the appliance

-OR-

Touch your finger repeatedly to a green ground connection point or unpainted metal in the appliance.

• ■ Before removing the part from its package, touch the anti-static bag to a green ground connection point or unpainted metal in the appliance.
• ■ Avoid touching electronic parts or terminal contacts; handle electronic control assembly by edges only.
• ■ When repackaging failed electronic control assembly in anti-static bag, observe above instructions.

DIAGNOSTIC GUIDE

Before servicing, check the following:

• ■ Make sure there is power at the wall outlet.
• ■ Has a household fuse blown or circuit breaker tripped? Time delay fuse?
• ■ Are both hot and cold water faucets open and water supply hoses unobstructed?
• ■ All tests/checks should be made with a VOM or DVM having a sensitivity of 20,000 ohms per volt DC or greater.
• ■ Check all connections before replacing components. Look for broken or loose wires, failed terminals, or wires not pressed into connections far enough.
• ■ A potential cause of a control not functioning is corrosion on connections. Observe connections and check for continuity with an ohmmeter.
• ■ Connectors: Look at top of connector. Check for broken or loose wires. Check for wires not pressed into connector far enough to engage metal barbs.
• ■ Resistance checks must be made with power cord unplugged from outlet, and with wiring harness or connectors disconnected.
• ■ Verify washer operation by running a Service History Mode & Diagnostic Test. See page 5.

AVERTISSEMENT

Déconnecter la source de courant électrique avant l'entretien.

Risque de choc électrique

Replacer pièces et panneaux avant de faire la remise en marche.

Le non-respect de ces instructions peut causer un décès ou un choc électrique.

IMPORTANT

Circuits électroniques sensibles aux décharges électrostatiques

Le risque de décharge électrostatique est permanent. Une décharge électrostatique peut endommager ou affaiblir les composants électroniques. La nouvelle carte peut donner l'impression qu'elle fonctionne correctement après la réparation, mais une décharge électrostatique peut lui avoir fait subir des dommages qui provoqueront une défaillance plus tard.

• ■ Utiliser un bracelet de décharge électrostatique. Connecter le bracelet à la vis verte de liaison à la terre ou sur une surface métallique non peinte de l'appareil

-OU-

Tou