Введение
Follow this guide to replace a scratched or worn back cover for the Motorola Moto E5 Play.
Выберете то, что вам нужно
-
-
Insert your fingernail or the flat end of a spudger into the notch on the bottom right corner of the phone.
-
Pry with your fingernail or twist the spudger to release the back cover's clips from the phone.
-
-
-
Insert your fingernail or the flat end of a spudger into the seam on the bottom of the phone and slide it along the edge to release the clips holding the back cover to the phone.
-
-
-
-
Continue sliding your fingernail or spudger along the seam around the rest of the phone to release the remaining clips.
-
Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Motorola Moto E5 Play Answers community for troubleshooting help.
Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Motorola Moto E5 Play Answers community for troubleshooting help.
Отменить: Я не выполнил это руководство.
Еще один человек закончил это руководство.
