Сложность
Средняя
Шаги
8
Необходимое время
20 - 40 мин.
- Rear Glass Шагов: 3
- Battery Disconnect prereq 1 шаг
- Battery Шагов: 4
Предлагаемое руководство
Эта инструкция была специально выделена сотрудниками iFixit.
Введение
Use this guide to remove or replace a worn-out battery in a Sony Xperia Z5.
If your battery is swollen, take appropriate precautions. For your safety, discharge your battery below 25% before disassembling your phone. This reduces the risk of a dangerous thermal event if the battery is accidentally damaged during the repair.
If you do not replace the adhesive seals when reassembling, your device will function normally, but will most likely lose its water-protection.
You’ll need replacement adhesive to reattach components when reassembling the device.
-
-
Before you begin, switch off your phone.
-
Apply a heated iOpener to the edges on the back of the phone to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes.
-
-
-
Secure a suction handle to the bottom of the rear glass, as close to the edge as possible.
-
Pull up the suction handle to generate a gap.
-
Insert an opening pick into the gap to further separate the rear glass from the phone assembly.
-
-
-
-
-
Use a spudger to pry up and disconnect the battery flex cable.
-
-
-
Use a pair of tweezers to pull out the first adhesive strip from underneath the battery.
-
-
-
Use a pair of tweezers to pull out the second adhesive strip from underneath the battery.
-
-
-
Use an opening pick to pry the battery out of its recess until you can get a good grip.
-
-
If possible, turn on your phone and test your repair before installing new adhesive and resealing the phone.
Secure the new battery with pre-cut adhesive or double-sided adhesive tape. In order to position it correctly, apply the new adhesive into the phone at the places where the old adhesive was located, not directly onto the battery. Press the new battery firmly into place.
For optimal performance, calibrate your newly installed battery: Charge it to 100%, and keep charging it for at least two more hours. Then, use it until it shuts off due to low battery. Finally, charge it uninterrupted to 100%
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Answers community for troubleshooting help.
If possible, turn on your phone and test your repair before installing new adhesive and resealing the phone.
Secure the new battery with pre-cut adhesive or double-sided adhesive tape. In order to position it correctly, apply the new adhesive into the phone at the places where the old adhesive was located, not directly onto the battery. Press the new battery firmly into place.
For optimal performance, calibrate your newly installed battery: Charge it to 100%, and keep charging it for at least two more hours. Then, use it until it shuts off due to low battery. Finally, charge it uninterrupted to 100%
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Answers community for troubleshooting help.
Отменить: Я не выполнил это руководство.
3 участников успешно повторили данное руководство.
Комментариев: 2
Clear & simple giude, though he doesn't say you need 5 hands!
You also need a strip of Sony Xperia Z5 Battery Adhesive Tape
