Почините Свои Вещи Сообщество Магазин

iPhone 8 Plus 电池更换指南

Примечание: Вы редактируете необходимое руководство. Любые внесенные вами изменения повлияют на руководство, которое включает эту стадию.

Назад к руководству
Английский
Китайский
Шаг 5
iPhone 8 Plus Battery Replacement: шаг 0, изображение 1 из 2 iPhone 8 Plus Battery Replacement: шаг 0, изображение 2 из 2

  • If any of the adhesive strips broke off and the battery remains stuck to the rear case, remove it by adding a few drops of isopropyl alcohol (90% or greater) underneath the battery near the stuck strip(s). After about a minute, gently lift the battery.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • If you choose to use pry tools to lift the battery out of the iPhone, use extreme caution or you may damage the ribbon cables or the wireless charging coil directly underneath the battery.

  • If the battery remains stuck to the rear case, prepare an iOpener or use a hair dryer to heat the rear case directly behind the battery. This will help soften the adhesive.

  • Heat the iPhone until the rear case is slightly too hot to comfortably touch. Don't overheat the iPhone, or you may accidentally ignite the battery.

  • Alternatively, thread a strong piece of string (such as dental floss or a length of thin guitar string) underneath the battery.

  • Pull the string from side to side in a sawing motion all along the length of the battery to separate the adhesive. Do not deform or damage the battery.

  • To protect your fingers, wear gloves or wrap the string ends around a tool (such as the two screwdriver handles shown in the image).

如果有任何胶条断裂，电池仍然粘在后壳上，请在电池下面靠近被粘住的胶条处滴几滴酒精（90%或更高），将其移除。大约一分钟后，轻轻地提起电池。

不要试图强行撬出电池。如果需要，再滴上几滴异丙醇，以进一步削弱粘合剂。千万不要用你的撬动工具使电池变形或刺破。

如果你选择使用撬动工具将电池从iPhone中抬出，要特别小心，否则你可能会损坏带状电缆或电池正下方的无线充电线圈。

如果电池仍然粘在后壳上，请准备一个iOpener或用吹风机直接加热电池后面的后壳。这将有助于软化粘合剂。

加热iPhone，直到后壳有点烫手，但还可以舒适地触摸的程度。不要过度加热iPhone，否则你可能会意外地点燃电池。

或者，在电池下面穿一条结实的绳子（如牙线或一段细的吉他弦）。

沿着电池的长度，将绳子从一边拉到另一边，做锯齿状运动，以分离粘合剂。不要使电池变形或损坏。

为了保护你的手指，请戴上手套或将绳子的两端缠绕在工具上（如图中所示的两个螺丝刀手柄）。

Ваш вклад лицензируется под свободной лицензией Creative Commons .