I have a Samsung TV that uses an antenna. I also have LED light fixtures that are mounted on my walls, if I move the antenna close to the light I get the same interference you seem to have. The electronics in the LED light bulb generate interference so the solution is to move the antenna away from the LED source.

Just got my Ninja working from the same problem you describe. What I did: removed the bottom which exposes a flow meter. I removed and disassembled the flow meter to make sure the little wheel spun freely, and it seemed fine. I spent time examining and learning the guts of the machine, reassembled and tested the coffee maker. IT WORKED LIKE A CHARM! ONE OF TWO THINGS IS GOING ON: 1. Either the flow meter was not turning, telling the machine to shut down. Or 2. The water in the piping somehow “vapor locked” keeping the water from flowing through to the flow meter. OBSERVATION: During tear down and assembly I had the machine on it’s back top and sides and water leaked onto my bench. What I would suggest trying: Before tearing into your machine, try laying the machine on it’s back, top and sides for a few minutes each, on a towel. If this is a vapor lock issue it may dislodge an air bubble in the tubing that might be causing the problem. When I disassemble my machine I disconnected tubes to the flow meter...