H4CK3R

Ps3 yellow light quick fix. No opening Keep turning it on. Let it kick off and just keep pressing power it will stay on eventually. Or open it up. Clean the dust out. Reapply thermal paste to the heatsink. Then bend the CPU tension plates on the bottem to make it tighter before reassembling. Heat up the two large chips on the board with a heat gun or hair dryer as hot as you can get it without melting anything then reassemble it. It should work fine after that.

I found cheap CD bay drives can't by used like normal. Format it using a proper USB HDD caddy then reincert it in your machine. I would recommend using it as extra storage not a second o.s

Have you tried holding the main screen key and the lock key at the same time

The flat screen plug has a spring clip on each side try squeezing it. Here --->. /---------\ <------ and here then inserting it (for connector at screen end)

Your Lithium battery's may be sleeping. Sleeping lithium battery's are battery's that have lost capacity or entire cells. Its possible your battery is dead or one cell Once a lithium drops below the low voltage cutoff it will it will sleep producing no power. Even if the battery is a 3.7v it may have 3 cells in it. And one has dropped below 2.4v causing the battery to turn off. If the cell is bad it will take out the rest. If you don't want to buy a new battery. You can try a external universal charger and see if that charges it.

Your charging block may be damaged. This happens to non OEM. Cords/blocks. In sum cases I found the power block voltage spiked and sent to much power to the phone and it burned the ribbon cord that connects the power port to the main board.

Try factory wipe and in restore mode.

Dose the phone feel warm? Could be a failing chip on your phone or a temp sensor Have you tryed a factory restore? In sum cases you need to reload a new clean iOS on your phone or tablet to allow the battery to function normally. Is it possible while installing the battery the ribbon may have been slightly damaged or not fully connected? Also make sure your power port is clean. Use a clean too the brush and get any gunk out. Hope you find this usefull

Your issue is a bad part. Possibly camera or gyro sensor. Here's a easy way to find out what went bad. Open the 5c. Remove the plates covering the connectors for the screen. (KEEP NOTE WHERE EACH SCREW CAME FROM. IF YOU PUT THE WRONG ONE IN THE WRONG SPOT. IT WILL DAMAGE THE BOARD remove or disconnect the camera. Try to boot with phone semi open. If it boots. Its a bad camera. If not. Unplug another connector and try again. It usually ends up being a gyro sensor. But if you still have a issue keep testing all connectors. In sum cases. It is the LCD or dijitiser (even if they work they can be bad) If you need to know how to do any steps. In sure there's a guide on ifixit Hope this helped.

I found this hope it helps. http://m.aliexpress.com/item/32460139536... Its a trusted supplier. Possibly eBay would be another guess