Неутвержденный перевод
Особая благодарность этим переводчикам:
en ru
100%
Юра Лотоцкийпомогает нам починить мир! Хотите внести свой вклад?
Начните переводить ›
Неутвержденный перевод
Особая благодарность этим переводчикам:
100%
Юра Лотоцкийпомогает нам починить мир! Хотите внести свой вклад?
Начните переводить ›
За последние 24часов: 3
За последние 7 дней: 13
За последние 30 дней: 31
За всё время: 2,938
10 Комментариев
How about a Typhoon H plus when you push the red button to start up the motors for flight and then all the light on the drone flash red and gives off three or so beeps. Can not fly at all. Even if you push the take off icon and select start the props spin up and then with in a few seconds it shuts down.
Bret Newman - Ответить
Hi
John J Cavanaugh here writing
I havent used my hplus for awhile especially during the winter months
here in New England. I'm in Massachusetts… USA
I've tried to charge the batteries and all that's happening is a blue error light everytime i try to charge each of my three fully discharged batteries… I've tried to find utube videos and have looked for other resources to resolve this issue…
The batteries too ; are slightly puffy/ puffed out as well. Not sure if that's apart of my problem here…
Please help
I thank you
John C
John J Cavanaugh - Ответить
My typhoon loon blaming purple
Melissa Coin - Ответить
Mt typhoon loon is blanking purple
Melissa Coin - Ответить
Re: The advice above about trying to resolve the Typhoon H not responding to the ST16 controller. "The Ground Station and Drone are not bound". It says to turn on the drone on first (Steps 1 and 2), then the Ground Controller (Steps 3 onward). My manual says to NEVER switch on the drone before the ground controller. On the Yuneec Pilots forum, owners have reported bricked equipment after doing this. What is the truth???
martin.redman - Ответить