In this guide, you will be able to access and remove the LCD screen from the camera's frame.


Никакие детали не требуются.

  1. Remove the following screws:
    • Remove the following screws:

      • Two silver 3.15mm Phillips #00 screws on the right side of the camera

      • Two silver 2.08mm Phillips #00 screws on the left side of the camera

    Добавить комментарий

  2. Remove the two indicated screws on the bottom of the camera:
    • Remove the two indicated screws on the bottom of the camera:

      • The screw circled in red is a longer silver 3.15mm Phillips #00 screw

      • The screw circled in blue is a shorter silver 2.25mm Phillips #00 screw

    Добавить комментарий

    • Carefully pull the back of casing away from the front.

    Добавить комментарий

    • After removing the back cover, several things must be removed.

    • Silver donut-shaped button will fall off. Place separately. Remove the plug covers on the right side of camera, labeled “PC/AV” and “DC IN 4.5V”.

    Добавить комментарий

    • To remove the front cover, gently hold the inside structure of the camera and slowly pull the front cover off.

    Добавить комментарий

    • On the front of the camera, in battery case, remove screws indicated:

      • Two black 2.05mm Phillips #00 screws

    Добавить комментарий

    • Flip the camera over to the backside and remove screws indicated:

      • The screw circled in red is a longer black 3.00mm Phillips #00 screw

      • The screw circled in red is a shorter black 2.00mm Phillips #00 screw

    Добавить комментарий

    • Pull the cover plate off for the two power cord jacks.

    Добавить комментарий

    • Cautiously and gently pull up the control board at the upper left corner, next to the viewfinder.

    Добавить комментарий

    • Remove the orange tape on top of the SD cardholder.

    Добавить комментарий

    • Open the battery cover and lift plastic piece off.

    Добавить комментарий

    • Remove tape on left side of camera.

    Добавить комментарий

    • Remove the indicated 2.40mm Phillips #00 screw to release top left LCD bracket.

    Добавить комментарий

    • Remove top left LCD bracket.

    • This is a small piece, be careful not to lose it.

    Добавить комментарий

    • Push down bottom left LCD bracket to release the LCD from grip.

    Добавить комментарий

    • Gently lift up LCD screen.

    Добавить комментарий

    • Slowly pull LCD screen to the left to remove it from the other grips.

    • BEWARE: The LCD screen is attached to the logic board by two wires at the bottom.

    Добавить комментарий


To reassemble your device, follow these instructions in reverse order.

Bassem Tossoun

Участник с: 21.01.2011

201 Репутация

Автор 2 руководств


Cal Poly, Team 4-29, Regan Winter 2011 Member of Cal Poly, Team 4-29, Regan Winter 2011


3 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 1

За всё время: 755