Введение

Use this guide to replace the logic board in your Alcatel Jitterbug Smart

  1. Pry back cover open with a medal spudger, or your fingernail, in the divot at the bottom left corner of the phone. Lift open case by the corner nearest the divot and remove it from the phone.
    • Pry back cover open with a medal spudger, or your fingernail, in the divot at the bottom left corner of the phone.

    • Lift open case by the corner nearest the divot and remove it from the phone.

  2. Remove the 13 1 mm Phillips screws with JIS #000 Screwdriver. Remove the 13 1 mm Phillips screws with JIS #000 Screwdriver.
    • Remove the 13 1 mm Phillips screws with JIS #000 Screwdriver.

  3. Free shipping on all orders over 100 $ or containing a Pro Tech Toolkit!

    Посмотрите наш магазин
  4. Gently pry off the Mid frame from the phone using a Metal Spudger. Gently pry off the Mid frame from the phone using a Metal Spudger.
    • Gently pry off the Mid frame from the phone using a Metal Spudger.

  5. Use the Plastic Opening tools to gently dislodge the broken camera from the inside of the phone. Use a tweezers to pull the camera connector from its port.
    • Use the Plastic Opening tools to gently dislodge the broken camera from the inside of the phone.

    • Use a tweezers to pull the camera connector from its port.

    • Be careful not to tear the camera from its connection.

Заключение

To reassemble your device, follow these instructions in reverse order.

Gavin Le

Участник с: 13.02.2018

313 Репутация

Автор 3 руководств

Команда

USF Tampa, Team S11-G4, Cheng Spring 2018 Member of USF Tampa, Team S11-G4, Cheng Spring 2018

USFT-CHENG-S18S11G4

4 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 2

За 30 дней: 6

За всё время: 70