Введение

Replacing the command screen is relatively simple. You will have to pop off a few parts from the lid section of the printer in order to get at the back part of the command screen. Once you have access to the command screen and the attached chip, you can unplug a few wires and remove the screen with a philips-head screwdriver. After you have removed the screen, put in a replacement and close the printer back up. Good Luck!

Запчасти

Никакие детали не требуются.

Open top lid of the printer to reveal the scanner
  • Open top lid of the printer to reveal the scanner

Добавить комментарий

Insert the spudger tool into the top lid  in between the blue and the black panels. Use this tool to pry the two panels apart
  • Insert the spudger tool into the top lid in between the blue and the black panels.

  • Use this tool to pry the two panels apart

Добавить комментарий

After these two panels are separated, set the top panel to the side for now
  • After these two panels are separated, set the top panel to the side for now

Добавить комментарий

Unplug the two wires shown at the right of the command screen
  • Unplug the two wires shown at the right of the command screen

Добавить комментарий

Unscrew the four screws shown to detach the command screen from the printer
  • Unscrew the four screws shown to detach the command screen from the printer

Добавить комментарий

Take the detached command screen off of the printer and replace.
  • Take the detached command screen off of the printer and replace.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

4 участников успешно повторили данное руководство.

Val Fedorikhin

Участник с: 12.10.2014

848 Репутация

Автор 5 руководств

Команда

Cal Poly, Team 6-21, Maness Fall 2014 Member of Cal Poly, Team 6-21, Maness Fall 2014

CPSU-MANESS-F14S6G21

4 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 1

За 7 дней: 3

За 30 дней: 14

За всё время: 573