Введение
Most of the components are inside of the unit. It is necessary to open the unit in order to access these components. Take care not to damage the ribbon cable connector upon removal. This guide will show you how to disassemble the unit.
Выберете то, что вам нужно
-
-
Flip the device over.
-
Remove the four 10mm PH #2 screws by rotating the screwdriver counterclockwise, removing the screw from the housing completely.
Спросите у FixBot
-
-
-
-
Separate the two cover pieces carefully by pulling apart the two cover pieces away from each other.
-
To reassemble the unit, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
Еще один человек закончил это руководство.
Команда
Idaho State University, Team S4-G1, Watkins Fall 2017 Участник Idaho State University, Team S4-G1, Watkins Fall 2017
ISU-WATKINS-F17S4G1
3 членов
Автор 5 руководств
