Epson EX90 Lamp Replacement

Присоединяйся к сообществу ремонтников - Создай аккаунт

Введение

Epson EX90 is a portable projector that uses a 170W UHE E-TORL lamp. The average lamp life is around 3,000 hours.

If the lamp indicator flashes red or the projected image is darker, it is recommended to replace the lamp. This guide will explain how to replace the lamp on the Epson EX90. It is recommended to replace the bulb as soon as possible due to the reason below,

WARNING While rare, a bulb could explode for the following:

the bulb reached the end of its lifespan
bulb overheated
Improper installation

If this happens, please turn off and then unplug the projector. Thoroughly remove glass shards and vacuum around and in the projector before replacing lamp.

1. Шаг 1 Lamp
  Turn off the projector and unplug the power cable.
  
  Allow the projector to cool down for at least one hour (or until the lamp is cool).
  Редактировать
  
  Спросите у FixBot
  
  Добавить комментарий
  
  1024
3. Шаг 2
  Loosen the screw holding the lamp cover on top of the projector.
  
  Slide the cover out of the projector.
  Редактировать
  
  Спросите у FixBot
  
  Добавить комментарий
  
  1024
4. Шаг 3
  Loosen the two captive screws holding the lamp in place.
  
  Use your hands to pull the lamp straight up and out of the projector.
  Редактировать
  
  Спросите у FixBot
  
  Добавить комментарий
  
  1024