Введение

This guide will show how to remove and replace the RAM of the IBM Thinkpad T60. Remember to always power down the computer before attempting any installation/removal of any hardware components. Be sure to remove the AC adapter and all cables from the computer. If the computer has been on, wait several minutes before beginning the procedure to ensure all parts have cooled down.

Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.
  • Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.

  • Use your finger to slide the tab to the right to unlock the battery.

Добавить комментарий

Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad. The battery is now disconnected.
  • Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad.

  • The battery is now disconnected.

Добавить комментарий

Using a #0 Phillips screwdriver, remove the four 17.0 mm screws. Using a #0 Phillips screwdriver, remove the four 17.0 mm screws.
  • Using a #0 Phillips screwdriver, remove the four 17.0 mm screws.

Добавить комментарий

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Turn the computer back over, so that the top is facing upwards.
  • Turn the computer back over, so that the top is facing upwards.

  • Open the display to access the palm rest. Apply pressure to the sides of the palm rest so that it bends upwards in the middle. Then gently lift away from the computer.

Добавить комментарий

Slightly lift the palm rest away from the computer. The touchpad's data cable connects the palm rest to the base unit. BE CAREUL!
  • Slightly lift the palm rest away from the computer.

    • The touchpad's data cable connects the palm rest to the base unit. BE CAREUL!

  • Detach the connector by pulling upwards on the white tab.

Putting it back on should be covered too, as it’s really hard to get everything lined up. Would be nice for some tips on that. Took me and other experienced guy 45 minutes to get the thing back on, and have all the screws seat!

Glenn - Ответить

Press out the two tabs on either side of the card at the same time. The memory card will slide upwards at a 20 degree angle.
  • Press out the two tabs on either side of the card at the same time.

  • The memory card will slide upwards at a 20 degree angle.

Добавить комментарий

Remove the memory card from the slot by pulling perpendicular to the slot.
  • Remove the memory card from the slot by pulling perpendicular to the slot.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

10 участников успешно повторили данное руководство.

Cody Kratochvil

Участник с: 11.01.2013

388 Репутация

Автор 10 руководств

Команда

Cal Poly, Team 7-9, Maness Winter 2013 Member of Cal Poly, Team 7-9, Maness Winter 2013

CPSU-MANESS-W13S7G9

4 членов

Автор 16 руководств

Один комментарий

Добавить комментарий

Просмотр статистики:

За 24 часа: 7

За 7 дней: 37

За 30 дней: 178

За всё время: 9,664