Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Введение

This guide will assist with replacing a non-functioning projector lamp, which is responsible for providing the light necessary for projection.

Запчасти

Детали не указаны.

  1. Place the projector on its back with the control buttons facing down. Remove the black  7mm screw on the external case with a Phillips 2 screwdriver.
    • Place the projector on its back with the control buttons facing down.

    • Remove the black 7mm screw on the external case with a Phillips 2 screwdriver.

  2. Use the plastic flat-head to remove the lamp lid.
    • Use the plastic flat-head to remove the lamp lid.

  3. OPEN ALL THE TABS

    RAM Upgrade Kits for Mac

    Shop Kits

    Enough RAM
    For All The Tabs

    Shop Kits
  4. Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head. Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.
    • Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head.

    • Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.

  5. Grab the silver handle. Unhook the handle so it can move freely. Pull the handle straight up until the lamp is completely removed from projector.
    • Grab the silver handle.

    • Unhook the handle so it can move freely.

    • Pull the handle straight up until the lamp is completely removed from projector.

Заключение

To reassemble your device, follow these instructions in reverse order.

Еще один человек закончил это руководство.

Jorge L Navarro

Участник с: 22.01.2014

533 Репутация

Автор 5 руководств

Команда

Cal Poly, Team 13-17, Regan Winter 2014 Участник Cal Poly, Team 13-17, Regan Winter 2014

CPSU-REGAN-W14S13G17

6 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 4

За последние 30 дней: 19

За всё время: 2,370