Введение

Steps to remove LG VX8550 keypad housing

Запчасти

Никакие детали не требуются.

  1. Slide the battery release up.
    • Slide the battery release up.

  2. Remove the battery by lifting away from the case.
    • Remove the battery by lifting away from the case.

  3. Remove the 2 screw covers next to the rear speaker with a Push Pin.
    • Remove the 2 screw covers next to the rear speaker with a Push Pin.

  4. Remove the 4 cover screws with a Philips #00 screwdriver.
    • Remove the 4 cover screws with a Philips #00 screwdriver.

  5. Use the iPod opening tool to pry off the back casing.
    • Use the iPod opening tool to pry off the back casing.

  6. Free shipping on all orders over 100,00 $ or containing a Pro Tech Toolkit!

    Посмотрите наш магазин

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  7. Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.
    • Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.

  8. Separate the casing halves.
    • Separate the casing halves.

    • Be sure to keep track of the side buttons as they fall out.

  9. Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.
    • Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.

  10. Carefully lift up on the motherboard to see the ribbon cables underneath.
    • Carefully lift up on the motherboard to see the ribbon cables underneath.

    • Use the spudger to carefully disconnect the ribbon cable from the motherboard.

  11. Remove the motherboard from the front casing by lifting straight up.
    • Remove the motherboard from the front casing by lifting straight up.

  12. Lay the phone with the screen facedown.
    • Lay the phone with the screen facedown.

    • The 6 slider screws are visible.

  13. Peel back but don't remove the blue tape to access the 2 center screws.
    • Peel back but don't remove the blue tape to access the 2 center screws.

    • Remove the 6 slider screws with the Phillips #00 screwdriver.

  14. Lift the keypad housing away from the slider.
    • Lift the keypad housing away from the slider.

Заключение

To reassemble your device, follow these instructions in reverse order.

Nathan Jones

Участник с: 10.04.2010

83 Репутация

Автор 10 руководств

Команда

Cal Poly, Team 34-55, Forte Spring 2010 Member of Cal Poly, Team 34-55, Forte Spring 2010

CPSU-FORTE-S10S34G55

5 членов

Автор 20 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 0

За всё время: 1,840