Введение

Use this guide to replace the back cover.

Remove the four 3.0mm screws on the bottom of the camera.
  • Remove the four 3.0mm screws on the bottom of the camera.

Добавить комментарий

Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.
  • Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.

Добавить комментарий

Remove the two 3.0mm screws on the right side of the camera.
  • Remove the two 3.0mm screws on the right side of the camera.

Добавить комментарий

Carefully open the back cover. Take care as there are connectors still attached.
  • Carefully open the back cover. Take care as there are connectors still attached.

Добавить комментарий

Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.
  • Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.

Добавить комментарий

Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.
  • Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.

  • The back cover will be disconnected from the camera

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

Kaky Payne

Member since: 17.04.2012

58 Репутация

Автор 5 руководств

Команда

Cal Poly, Team 12-38, Regan Spring 2012 Member of Cal Poly, Team 12-38, Regan Spring 2012

CPSU-REGAN-S12S12G38

4 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 1

За 30 дней: 8

За всё время: 875