Перейти к основному содержанию
Присоединяйся к сообществу ремонтников - Создай аккаунт

Pokewalker Button Replacement

Выберете то, что вам нужно

  1. Pokewalker Button Replacement, Battery: шаг 1, изображение 1 из 1
    • Locate the Screw on the Back of the Pokewalker.

  2. Pokewalker Button Replacement: шаг 2, изображение 1 из 1
    • Remove the Screw with a Phillips #0 Screwdriver

    • The screw is attached to the rear case with washers. don't worry about losing it.

  3. Pokewalker Button Replacement: шаг 3, изображение 1 из 1
    • Remove the Rear Cover from the Device

  4. Pokewalker Button Replacement: шаг 4, изображение 1 из 1
    • Use the flat end of a Spudger to Remove the Battery

    • Locate the 4 Screws Around the Device

    • Remove all 4 screws with a Y0 Triwing Screwdriver

    • Separate the 2 halves of the Device

    • Do not Separate Completely as the Display is Still Connected by a Ribbon Cable

  5. Инструмент, используемый на этом этапе:
    Tweezers
    $4.99
    • Use a Spudger to Flip the Latch holding the ribbon cable in place and use Tweezers to Pull it out

    • Do not use Excessive force when reinserting the cable, because ribbon cables are fragile

    • Remove the Rubber-button thingy from the upper case

    • I have no idea what that thing is, edit this guide if you do.

    • Remove the 3 Plastic Buttons from the Case

    • It helps that the buttons only go in one way, makes it easier to reassemble

Заключение

To reassemble your device, follow these instructions in reverse order.

Winni Stuart

Участник с: 04/13/14

447 Репутация

Автор 2 руководств

0 Комментарии к руководству

Добавить комментарий

Статистика просмотров:

За последние 24 часов: 3

За последние 7 дней: 14

За последние 30 дней: 72

За всё время: 1,064